ReplayTV 2000/3000/Showstopper Motherboard Replacement
Warning - Unplug power cord before working on recorder
Touch hand to bare metal on recorder case to discharge static electricity before touching hard disk or motherboard
Remove 7 cover hold down screws from underside and rear of cover
Remove motherboard rear attaching hardware i.e. 1 nut and washer, 4 screws and 2 studs from rear of case
Lift 4 connectors from motherboard. Wiggling and pulling at the same time aid removal
Remove 5 hard drive cover screws. Remove cover, foam sheet and hard drive
Remove 5 hard drive mount studs
Swing mount out of the way
Remove 8 motherboard attaching screws
Lift out motherboard
To install motherboard, reverse steps
Wiggle board until seated in rear of recorder. Install rear hardware before tightening 8 motherboard attaching screws
All connectors must be installed as seen. Align power supply board and IR panel ribbon receptacle onto pins. Erroneous connection may cause irreversible damage to electronic components
Once recorder is fully assembled, plug AC power cord in and enjoy the wonderful world of ReplayTV!